Tesla Model S Front Door Speaker Mount - image

Files (3)

SpeakerBase_Final.STL

STL

244.5 KB

SpeakerConnector_Final.STL

STL

5.4 KB

SpeakerMount_Final.STL

STL

157.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	ABS 20%	ABS 40%	100% solid	Recommendation
SpeakerBase_Final.STL	Printable file	244.5 KB STL	Slice file	Slice file	Slice file	Use acetone to create a strong bond between the two printed pieces
SpeakerConnector_Final.STL	Accessory piece	5.4 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
SpeakerMount_Final.STL	Mount / bracket	157.7 KB STL	Slice file	Slice file	Slice file	Use acetone to create a strong bond between the two printed pieces

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Door Panels

Tesla Model S Front Door Speaker Mount

0 downloads30 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a speaker mount to replace the front door factory standard speakers on a Tesla Model S with Infinity Kappa 62.11I 6 1/2" speakers. It comes in two pieces as I didn't want to attempt a design as one with a bunch of supports. The speaker mount attaches to the speaker which then fits inside of the speaker base. You may need to do a little sanding for them to fit together as I did. They are then permanently "welded" together with acetone to create a tight bond. You must use abs filament for this to work. You may also want to put the two pieces together in an acetone vapor bath to prevent any layer separation since the Kappa speakers are considerably heavier than the factory speakers. Also included is the connector that attaches to the factory wire harnes on the door. Insert speaker wire into terminals and then insert into the connector. It will need a bit of force to get in. You can find the terminal on Amazon. Search for "MQD-1I 18-22 AWG 1/8" Male Tab Crimp Connector Solderless Terminal". Use hot glue or superglue to secure to connector.