Tesla Model Y charging spacer for Samsung Galaxy Z Flip3 - image

Files (1)

shapr3d_export_2021-09-30_00h25m.stl

STL

435.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
shapr3d_export_2021-09-30_00h25m.stl	Primary model	435.8 KB STL	Slice file	Slice file	Slice file	Ensure the print bed is level and clean for optimal adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Tesla Model Y charging spacer for Samsung Galaxy Z Flip3

0 downloads41 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

The charging coil on the Samsung Galaxy Z Flip 3 is positioned too low to charge in the Tesla Model Y (2021 refresh) wireless charging console. This increases the height of the phone just enough to engage wireless charging. Unfortunately this does not leave room for the phone to unfold but there is no better solution that I could find other than using a cord.