Tesla_Parking_Spot_v8.stl

STL

213.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Tesla_Parking_Spot_v8.stl	Primary model	213.3 KB STL	Slice file	Slice file	Slice file	Ensure the center hole is clear of supports for the wireless charger to fit

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Tesla Parking Spot for Wireless Charger

0 downloads73 views0 likes

Shared by

Verified

Description

I really like the Supercharger model but I find that most of the time I charge my phone wirelessly. I designed this "Parking Spot" to go with the model by swholmstead. The center hole is designed to accept a Anker Wireless Charger. https://www.amazon.ca/Anker-Wireless-Charger-Charging-Qi-Enabled/dp/B00Y839YMU/ref=sr_1_6?crid=20PX5AIALE7M9&keywords=anker+wireless+charger&qid=1555849086&s=gateway&sprefix=anker+%2Caps%2C481&sr=8-6 It uses all of the parts of swholmstead's model except for the base pieces ("Base" and "Cap"). The side grey poles may need to be stretched in length as I made the mating holes in the base deeper to prevent print failures where the bottom meets the low infill.