Tesla Wheel Center Cap - Color Inset - image

Files (3)

cap_logo_bottom.stl

STL

15.3 KB

cap_logo_top.stl

STL

4.6 KB

center_cap_inset.stl

STL

1.1 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
cap_logo_bottom.stl	Cover / cap	15.3 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
cap_logo_top.stl	Cover / cap	4.6 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
center_cap_inset.stl	Cover / cap	1.1 MB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Emblems/Badges

Tesla Wheel Center Cap - Color Inset

0 downloads27 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

The original center cap that I made up had either inset or raised logos, but it was just a single color. A number of folks have remixed it into a two-part print so you could print the logo separate from the base and get two colors. I saw this nice tutorial on how to print multi-color objects with a single extruder (as long as you only need multi-colors on the first few layers): https://www.youtube.com/watch?v=KV2AjyowXX4 So i re-mixed the wheel center caps to work with this approach.