Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Tesla Wireless Charger

0 downloads35 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

This is a wireless QI charger for the Tesla Model S and Model X. The chargers is based on an IKEA Wireless Charger, that means “everyone” could get one without figuring out what charger coil that fits this design. Dismantle the IKEA Charger, remove the two pad under it, unscrew three screws – keep then for later. Take out the electronics, and pop it inside this design. Screw the Lid on with the three screws. The Phone Holders are easy interchangeable. The “block” that fits into the charge plate are 29,4mm x 2,8mm and 10mm deep. Design your “claws” that fits your phone. The one attached here are for Galaxy Note 9 or 10 with Samsung Original Cover. The Charge Plate and USB are printed with support touching build plate. The Lid and Phone Holders are not. The Wireless Charger from IKEA is “LIVBOJ” about $5. https://www.ikea.com/no/no/p/livboj-tradlos-lader-svart-40447051/ Happy Printing!