Tow Hook Cover for a 2001-2006 Audi TT - image

Files (1)

Audi_Tow_Plug.STL

STL

244.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Audi_Tow_Plug.STL	Primary model	244.3 KB STL	Slice file	Slice file	Slice file	Print with the flat face aligned to the print bed for optimal adhesion and minimal warping.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Exterior

Tow Hook Cover for a 2001-2006 Audi TT

0 downloads53 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is the cover which hides the rear tow hook (or screw hole, or plug, or whatever you call it) on a 2001-2006 Audi TT. This is from the Quattro model. It is a near-replica of the original. I changed the design of the center retainer to make it a friction fit so as not to rely on the strength of the material itself. The face of the original has a slight curvature that I left flat for ease of printing. Align that face with your print bed. Print it if you need it.