toyota brake pedal switch stopper pad and clutch end pad - image

Files (1)

cushion_pad.stl

STL

130.7 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

32g

Based on 100% main infill across listed model files

Material cost

$0.76

Filament only at roughly $24/kg TPU

Print time

54m–1.5h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	TPU 20%	TPU 100%	100% solid	Recommendation
cushion_pad.stl	Primary model	130.7 KB STL	13g $0.32	32g $0.76	32g $0.76	Print at least 7-8 at a time for proper cooling

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

toyota brake pedal switch stopper pad and clutch end pad

1 downloads123 views0 likes

Shared by

Alfred

Verified

Description

Cushion for Brake or Clutch Pedal Stop Pad STOP LAMP SWITCH for Toyota or Lexus needed one but couldn't find one that is good enough so here my version. important notes, do not print one at a time print at least 7 or 8 at the same time so top cools enough and you don't end up with a bloby mess. use tpu or petg or abs but I strongly recommend tpu. make sure infill is 100% and 2 walls.