Toyota Highlander QI Wireless Charger Replacement Trim Piece - image

Files (1)

QiWirelessMandrel2.stl

STL

39.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
QiWirelessMandrel2.stl	Primary model	39.9 KB STL	Slice file	Slice file	Slice file	Ensure proper fit over the plastic hinge pins

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Trim Pieces

Toyota Highlander QI Wireless Charger Replacement Trim Piece

0 downloads50 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

My 2021 Highlander came with a QI Wireless cellphone charger. My phone (2021 Moto ACE) cannot use a QI charger. The Highlander QI charger sits on top of the center console and must be moved out of the way to get at anything in or out of the console. Not a good design in my opinion. This trim piece fits over the plastic hinge pins that are obvious when the QI charger is removed. Remove the charger by removing all the phillips screws, unplug the connector and cover the exposed hinge pins with this trim piece. I used 4 x 3mm x 9mm self-taping screws. Printed with PETG to minimize heat and sun exposure issues. This may fit other years including 2020. Designed in SketchUp (file included).