Toyota Tacoma 2nd Gen Head Unit Trim Clip - image

Files (1)

Tacoma_Dash_Trim_Clip_v2.2.stl

STL

113.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Tacoma_Dash_Trim_Clip_v2.2.stl	Clip	113.2 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation for optimal strength and minimal supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Trim Pieces

Toyota Tacoma 2nd Gen Head Unit Trim Clip

0 downloads39 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Had to lengthen and flatten the clip a bit to make it work for the Tacoma head unit bezel. Gray PLA prototypes in picture were too short and would break or pop off into the dash. Yellow cip is the original I found under the cup holders (same clip used) AFTER I finished installing the radio, lol. Printed longer final version in ABS for more flexibility.