Files (6)
Choose the needed variant and slice it; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| back_wall.stl | Accessory piece | 6.9 KB STL | Slice file | Slice file | Slice file | Small functional file: print slowly; consider 80–100% infill for durability. |
| center_wall.stl | Accessory piece | 1.4 KB STL | Slice file | Slice file | Slice file | Small functional file: print slowly; consider 80–100% infill for durability. |
| console_example.stl | Printable file | 69.0 KB STL | Slice file | Slice file | Slice file | Print with a higher layer height for easier assembly |
| front_wall.stl | Accessory piece | 6.7 KB STL | Slice file | Slice file | Slice file | Small functional file: print slowly; consider 80–100% infill for durability. |
| pole.stl | Accessory piece | 13.6 KB STL | Slice file | Slice file | Slice file | Small functional file: print slowly; consider 80–100% infill for durability. |
| side_wall.stl | Accessory piece | 6.9 KB STL | Slice file | Slice file | Slice file | Small functional file: print slowly; consider 80–100% infill for durability. |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Toyota Tacoma center console organizer
Shared by
3DPrintedCarPartDescription
Toyota Tacoma 3rd gen (2015+) center console organizer/divider. It is 5.25 inches tall and will work with the trays that sit at the top of the console. For the full divider you will need to print Pole x2 Center wall x1 Side wall x2 Front wall x2 Back wall x2 You can customize this, leaving panels out for larger individual compartments I used.15 layer height for the poles and center wall so they slide together a bit easier. With the other walls laying on the flared spine to print, they will slide in easier if you wanted to try and bump up the layer height more. Also helps a bit to keep the prints stable while printing the top layers. Also used PETG since it withstands higher temps The side walls slant outward at the top ( \ / ) while the front and back slant inward at the top ( / \ ). You will have to put the console in at an angle and turn it into place inside the console. You may have to do this in pieces to get it to fit.
Compatible Cars
Originally published on thingiverse.com by brad barnes (bradb7888) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
