Toyota Tacoma Radio Mount CB or FTM-400XDR - image

Files (3)

Tacoma_Radio_Mount_14_deg.stl

STL

28.8 KB

Tacoma_Radio_Mount_5_deg.stl

STL

28.0 KB

Tacoma_Radio_Mount_Flat.stl

STL

28.0 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Tacoma_Radio_Mount_14_deg.stl	Mount / bracket	28.8 KB STL	Slice file	Slice file	Slice file	Ensure the print bed is level and clean for a strong bond
Tacoma_Radio_Mount_5_deg.stl	Mount / bracket	28.0 KB STL	Slice file	Slice file	Slice file	Ensure the print bed is level and clean for a strong bond
Tacoma_Radio_Mount_Flat.stl	Mount / bracket	28.0 KB STL	Slice file	Slice file	Slice file	Ensure the print bed is level and clean for a strong bond

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Center Console

Toyota Tacoma Radio Mount CB or FTM-400XDR

0 downloads49 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a mount I made to install my FTM-400XDR controller head into the storage bin of the console in my Toyota Tacoma pickup truck. It will likely also fit the FTM-300DR and the FTM-100DR radios as well. Us an M5x10 screw to mount the control head to the top surface. The mount may be fixed to the console bin using adhesive-backed velcro. I sprayed the top of the mount with a few coats of FlexSeal to add some friction. Since there is only one mounting screw, the friction keeps the control head from spinning. Make sure the FlexSeal (or equivalent) is totally dry before mounting the control head. I posted a YouTube video of the install at this link: https://youtu.be/LjA46Mhwwwg