Toyota Yaris rear wiper attachment replacement (2005-2011) - image

Files (1)

wiper_end_replacement.STL

STL

831.3 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

28g

Based on 25% main infill across listed model files

Material cost

$0.67

Filament only at roughly $24/kg PETG / ASA

Print time

48m–1.3h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
wiper_end_replacement.STL	Primary model	831.3 KB STL	26g $0.62	28g $0.67	62g $1.48	Ensure a secure fit by adjusting the model's dimensions if necessary

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

Toyota Yaris rear wiper attachment replacement (2005-2011)

0 downloads40 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

my windshield wiper clip was snapped due to heavy snowfall. To replace the part, you will need to saw off the end of the wiper arm with the bad clip, insert the part (preferably printed in PETG, nylon, or ABS), and secure it with 4-6 M3 screws ( you can use M2 screws with threaded inserts aswell). Then just install it on the car goes well with this: https://www.thingiverse.com/thing:4949898