Trunk Cover Clip for BMW vehicle - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Trunk/Tailgate

Trunk Cover Clip for BMW vehicle

0 downloads40 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

BMW i3 Trunk Cover Clips to replace missing or broken clips. These are a bit longer than the original ones because I needed the length to tie off the string (the knot took some of the string length). I wanted the trunk to shut completely when the back hatch was closed. When I purchased my [used] BMW i3, the one trunk clip was missing and one was not connected to the trunk cover. I was not able to connect the one because there was no place to tie the string. I could have drilled a hole and tied it to the one clip but the string was too short since it was not meant to be tied.