Turbo Water/Oil gauge 52mm Audi A3 - image

Files (1)

Audi_A3._Blower_support_Boost-Oil-water.stl

STL

2.2 MB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

43g

Based on 25% main infill across listed model files

Material cost

$1.02

Filament only at roughly $24/kg PETG / ASA

Print time

1.2h–2.0h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Audi_A3._Blower_support_Boost-Oil-water.stl	Primary model	2.2 MB STL	39g $0.94	43g $1.02	93g $2.24	Ensure a clean and dry print bed for optimal adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Turbo Water/Oil gauge 52mm Audi A3

1 downloads54 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Descripción ESPAÑOL Soporte para medidores de presión(52mm) de turbo/ agua/ aceite en soplador de habitáculo. Description INGLES Support for turbo / water / oil pressure gauges(52mm) in a cabin blower. Instalación ESPAÑOL Ser cuidadoso en el proceso de montaje, hay piezas pequeñas y/o delicadas. Retirar el cromado embellecedor exterior cuidadosamente.(Este tiene posicion especifica de montaje, a traves de unas grapas de fijacion) Retirar las palas de control de flujo de aire. Instalar el medidor en el soporte antes de encajar el soporte en el soplador.(La cara plana se instala hacia dentro del soplador) Colocar el anillo en su correcta posición.(Si no entra con suabidad, no hagas fuerza, rotale hasta encontrar la posicion correcta) Installation INGLES Be careful in the assembly process, there are small and / or delicate parts. Carefully remove the chrome exterior trim (This has a specific mounting position, through fixing clips) Remove the air flow control blades. Install the meter on the bracket before snapping the bracket onto the blower.(Flat side installs into the blower) Place the ring in its correct position. (If it does not fit smoothly, do not force it, rotate it until you find the correct position).