Files (1)

umbrella_holder_lowered.stl

STL

80.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
umbrella_holder_lowered.stl	Mount / bracket	80.3 KB STL	Slice file	Slice file	Slice file	Ensure a strong adhesion to the print bed to prevent warping

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Organizers

V2 VW UP! umbrella holder

0 downloads43 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

There is a shorter design, but it required a bit too much of fiddling to get the top umbrella out, so I decided to make a 5cm longer version. These hooks hold two umbrellas and are to be installed into the rear seat anchors - on the back (boot) side of the rear seats. So you then have a nicely organised boot and no umbrellas are taking up the floor space. They can easily be removed by pulling in the direction indicated by the arrows in case the seats are to be folded flat. It is a great idea, so I extend my congratulations to the original author.