Files (1)
Based on 25% main infill across listed model files
Filament only at roughly $24/kg PETG / ASA
Uses 70 mm/s, 0.2 mm layers; verify supports in slicer
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| Car_Magnet.stl | Primary model | 10.6 KB STL | 8g $0.20 | 9g $0.22 | 20g $0.47 | Small functional file: print slowly; consider 80–100% infill for durability. |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Vanderhall Glove Box Magnet Holder
Shared by
3DPrintedCarPartDescription
A simple print that holds a 1/4" cylinder magnet parallel to a surface. In this case it was designed to hold a magnet in a Vanderhall glove box as they are well known to open when accelerating fast when unlocked. For my Vanderhall nothing was magnetic so I had to tape a small piece of metal on the glove box swing bracket for the magnet to stick to. First I used a small piece double sided tape and moved the holder around the box to get the right location. Then I applied tape over the whole base and attached to the wall. The diameter is purposely smaller than 1/4. It will most likely require it to be drilled slightly out. This way you can get secure the magnet without glue.
Compatible Cars
Originally published on thingiverse.com by Shane Trapp (mncasper78) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
