Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| No printable model files are available for an estimate yet. | ||||||
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
VE Commodore / G8 Dash gauge pods
Shared by
3DPrintedCarPartDescription
I HAVE NOT RUN A TEST PRINT ON THESE! Measurements are revised from previous design, may still require slight sanding of lip to fit gauge. 3D printable Single, double and triple gauge pod options for Holden Commodore VE and Pontiac G8, designed specifically around Banks iDash but should fit other gauges. These install in the plastic center speaker grille, requires removal/modification of metal mesh. Played around with a design that didn't require cutting the support material from the plastic speaker grille but did not allow for as much movement to angle the gauges towards the driver.
Originally published on thingiverse.com by William Fox (vonrottes) · License: CC BY-NC-SA
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
