Volvo XC60/S60 cup holder insert preview

Files (1)

Volvo XC60 cup holder insert 1.stl

STL

129.5 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Volvo XC60 cup holder insert 1.stl	Mount / bracket	129.5 KB STL	Slice file	Slice file	Slice file	Check the final orientation and support structure in your slicer for optimal results

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

Volvo XC60/S60 cup holder insert

0 downloads83 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

25% infill with 3 walls

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

Some of the rubber holders have broken off in the cup holder of our XC60, which is a common problem. I made this insert to fit in the front cup holder so that a standard can or tall insulated bottle would stay supported and not tip over. Print in PETG or similar for durability, using supports as shown, 3 or so walls and 25% infill should suffice. The insert 2 has a dowel that fits into insert 1 and pushes under the trim to prevent the insert from pulling out easily. You may have to bend this slightly for a perfect fit. Enjoy:).