Files (1)

VWPlugWireHolder.stl

STL

552.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
VWPlugWireHolder.stl	Mount / bracket	552.1 KB STL	Slice file	Slice file	Slice file	Ensure proper fitment in the fan shroud

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

VW Spark Plug Wire Holder

0 downloads39 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Replaces the nylon wire holder that snaps into the fan shroud to keep the spark plug wires from wiggling all about the engine compartment. Printed mine in ABS and thus far has been heat-resistant. Then again, if your fan shroud gets that hot you might have another problem with your engine! There are two of these, one on each side of the shroud. The attached photo shows the original (white) and the printed part (black). The second photo shows the printed part installed on the driver's side of the shroud, behind the distributor. Designed in Autodesk Fusion 360 design files are available at https://a360.co/2xidj99.