Files (1)

W123_Dash_screw_cover_x1.stl

STL

19.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
W123_Dash_screw_cover_x1.stl	Cover / cap	19.4 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

W123 Dashboard Screw Cover

0 downloads52 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a little clip on cover for the screws that hold the under dash in place. The surface of the cover in place is the base as it is made, so you'll have a shiny cover unless you can texture your print bed to match the car. Another option might be to heat a leather-look surface to a high enough temperature to soften the plastic - and press the made cover into it until it makes an impression. I used PLA for the covers, although if you're somewhere with half decent weather you might have softening problems in sunshine. The model relies on good layer adhesion so ABS might not be the best material. PET(G) might work well.