1970-1972 Buick Skylark Gauge Adapter - image

Files (2)

GaugeFillerPlate-NoEmbossing.stl

STL

235.5 KB

GaugeMount.stl

STL

326.2 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

2 model files

Typical selected file

20g

Based on 25% main infill for the largest likely-needed model file

Material cost

$0.47

Filament only at roughly $24/kg PETG / ASA

Print time

34m–56m

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
GaugeFillerPlate-NoEmbossing.stl	Printable file	235.5 KB STL	16g $0.39	18g $0.42	38g $0.92	Ensure proper fit and clearance in the accessory panel slot before printing
GaugeMount.stl	Mount / bracket	326.2 KB STL	18g $0.43	20g $0.47	43g $1.03	Ensure proper fit and clearance in the accessory panel slot before printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

1970-1972 Buick Skylark Gauge Adapter

0 downloads46 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Gauge adapter for the accessory panel slot on 70-72 Buick Skylarks (maybe also 68-69). This adapter will fit a 2-1/16" (52.4mm) gauge and was designed for an AutoMeter full sweep electric fuel pressure gauge. Some cutting on the dash bezel will have to be done to fit the gauge. You will have to remove everything past where the clips on the accessory plate clip to for the gauge to fit.