2015 GMC Sierra Fuel Door Gas Cap Photogrammetry - image

Files (1)

FuelDoor.stl

STL

12.3 MB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

94g

Based on 25% main infill across listed model files

Material cost

$2.24

Filament only at roughly $24/kg ASA / ABS

Print time

2.7h–4.4h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	ASA / ABS 20%	ASA / ABS 25%	100% solid	Recommendation
FuelDoor.stl	Primary model	12.3 MB STL	86g $2.07	94g $2.24	205g $4.92	Ensure the entire bottom side is covered in support structure for successful printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Exterior

2015 GMC Sierra Fuel Door Gas Cap Photogrammetry

0 downloads61 views0 likes

Shared by

Alfred

Verified

Description

Hi, This is a 3D Scan done with photogrammetry of a 2015 GMC Sierra Fuel Door. The original was corroding, and I wanted to figure out photogrammetry, so this was a good test. Overall it did fairly well, but the edge is a little bumpy. I painted it flat black and speckled red paint on that to get good images for scanning. I used COLMAP and Meshlab. I printed it out of ABS. In S3D I did 8 top layers, 20 bottom layers, 5 perimeters, lots and lots of support. You want the entire bottom side to be covered in support structure.