2018 Toyota C-HR Floor Mat Retention Clip Grommet Turnbuckle - image

Files (2)

2018_Toyota_C-HR_Floor_Mat_Retention_Clip_Top_and_Bottom.3mf

3MF

111.1 KB

2018_Toyota_C-HR_Floor_Mat_Retention_Clip_Top_and_Bottom.stl

STL

373.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
2018_Toyota_C-HR_Floor_Mat_Retention_Clip_Top_and_Bottom.3mf	Clip	111.1 KB 3MF	Slice file	Slice file	Slice file	Ensure a clean and level print bed for proper adhesion
2018_Toyota_C-HR_Floor_Mat_Retention_Clip_Top_and_Bottom.stl	Clip	373.1 KB STL	Slice file	Slice file	Slice file	Ensure a clean and level print bed for proper adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

2018 Toyota C-HR Floor Mat Retention Clip Grommet Turnbuckle

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

USE AT YOUR OWN RISK WARNING: A malfunction of your driver's side floor mat can interfere with your ability to control your vehicle. Use at your own risk. THIS IS FOR EDUCATIONAL PURPOSES ONLY. THE AUTHORS TAKE NO RESPONSIBILITY OR LIABILITY FOR ANY DAMAGE, INJURY, OR DEATH THAT MAY OCCUR BY USING OR NOT USING THE PROVIDED FILES. Replacement for lost "Driver's side" floor mat retention clip. I got the idea from https://www.thingiverse.com/thing:4098627, but the design was slightly different than the factory measurements. Also I wanted it to stay attached to the floor mat when cleaning, so I designed a retention system as well that is simply pressure fit into place. The previous author got the idea from https://www.thingiverse.com/thing:3370713 but that one is too small for the their Avalon (it is for a different model).