Files (5)

69_POD-Bolt_Setup.stl

STL

259.4 KB

69_POD-Bottom-RIV.stl

STL

70.3 KB

69_POD-Bottom.stl

STL

63.1 KB

69_POD-Capture_Nut.stl

STL

257.2 KB

69_POD-RivNut.stl

STL

250.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

5 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
69_POD-Bolt_Setup.stl	Printable file	259.4 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports
69_POD-Bottom-RIV.stl	Printable file	70.3 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports
69_POD-Bottom.stl	Printable file	63.1 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports
69_POD-Capture_Nut.stl	Cover / cap	257.2 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.
69_POD-RivNut.stl	Printable file	250.3 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

69 Mustang Tach POD

0 downloads41 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a POD for a AutoMeter Mini Tach 2 1/16". It includes an area for the upper light fixture and allows the 2 bolts to slide through at the rear..... This requires a 1/8" Foam to be added to the the part that goes around the column, this is to prevent scratching and should also allow it to be fixed with out much movement I used https://www.amazon.com/dp/B07RYW3Q46 I have added 3 versions: RivNUT - This version you use a 10-24 rivnut into the hole at the bottom of the top half and glue it in...It fits without the glue and seems pretty snug but glue it in just to be safe. I use a 3/4" bolt/screw Bolt Setup - This one is made so you can use a bolt and nut to hold it together Capture Nut - Allows you to use a 1/4" bolt and and insert a nut into the back of the bezel. Nut should be flat to each side to be centered properly ***bottom-riv just has a smaller hole as i found the rivnut bolt was smaller but either can be used.