73-79 F-Series and 78-79 Bronco A/C & Heater Duct Adapters - image

Files (5)

Center_Duct_Adapter_Bottom.stl

STL

2.4 MB

Center_Duct_Adapter_Top.stl

STL

2.2 MB

Drivers_Duct_Adapter_Bottom.stl

STL

1.6 MB

Drivers_Duct_Adapter_Bottom_Angled.stl

STL

2.0 MB

Drivers_Duct_Adapter_Top.stl

STL

1.3 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

5 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	ASA / ABS 20%	ASA / ABS 25%	100% solid	Recommendation
Center_Duct_Adapter_Bottom.stl	Printable file	2.4 MB STL	Slice file	Slice file	Slice file	Ensure proper bed adhesion to prevent warping
Center_Duct_Adapter_Top.stl	Printable file	2.2 MB STL	Slice file	Slice file	Slice file	Ensure proper bed adhesion to prevent warping
Drivers_Duct_Adapter_Bottom.stl	Printable file	1.6 MB STL	Slice file	Slice file	Slice file	Ensure proper bed adhesion to prevent warping
Drivers_Duct_Adapter_Bottom_Angled.stl	Printable file	2.0 MB STL	Slice file	Slice file	Slice file	Ensure proper bed adhesion to prevent warping
Drivers_Duct_Adapter_Top.stl	Printable file	1.3 MB STL	Slice file	Slice file	Slice file	Ensure proper bed adhesion to prevent warping

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Vents

73-79 F-Series and 78-79 Bronco A/C & Heater Duct Adapters

0 downloads32 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I initially tried to print this https://www.thingiverse.com/thing:3887203 but it didn't work out so I designed my own that doesn't require supports. I use the same hose that is referenced in the other build. I also added a set of adapters for the drivers side vent. The angled drivers side adapter does require supports under the outlet that hangs over the build plate. Dorman 708-083 Use ABS or PLA or other high temp material as suggested sas64.