Alhambra, Sharan, Galaxy Seat Handle (Rear or Middle Seat) VW SEAT FORD - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Door Handles

Alhambra, Sharan, Galaxy Seat Handle (Rear or Middle Seat) VW SEAT FORD

0 downloads60 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

This is a Handle for my W-Reg (2000) 1.9 TDi PD 115BHp Seat Alhambra. I believe it's the same for the Ford Galaxy. I believe its the same for the Volkswagen (VW) Sharan (and maybe Touran). I had just one of the five left on the car when I bought it. That was already broken. So I got out BR's trademark "Cheapest Available" (tm) Pink filament, and printed a few of these babies out. Check it. It comes in two flavours. "Right" and "Left and Centre" - that relates to the seat position, not the side the handle is on (though I'd be real surprised if there was a handle in the centre of the seat back!). They have been built, and tested for the Right handle side. Fits with a little push. As ever, I recommend a Acetone Treatment for these and as it's got overhang I'm printing at 0.35mm Layer height (just going to check that's going to plan!) Enjoy, all you VWAG Diesel MPV Drivers just trying to keep the old girl running! License: Non-commercial, no derivatives, open source attribution. I can't enforce any of that, it's all BS. I just don't want to see someone using my files to add "Barry" or "Leeroy" to the handle and then re-uploading it "Look what I did!" - Brilliant. If you want to use this as a basis of your design - DO SO. Just no TRIVIAL derivatives. Change angles, Change faces, just none of this "My name on My handle" rubbish! Peace, out! EUR ING Andy Southern, aka BathRobotics. p.s. if you like this car part, why not download (or just view) the other designs I've done: 20/06/2016: VW Sharan / Alhmabra Rear Adjustment Handle http://www.thingiverse.com/thing:1586975 15/01/2016: VW Sharan Trim Clip (3D Printed) http://www.thingiverse.com/thing:1274409 14/01/2016: VW Sharan Trim Clip (as Mass-produced) http://www.thingiverse.com/thing:1261167 25/10/2015: Alhambra Seat Handle http://www.thingiverse.com/thing:1092459 11/01/2015: Toyota Engine Seal Fix http://www.thingiverse.com/thing:629300 12/08/2014: Toyota Avensis Parcel Shelf Clip http://www.thingiverse.com/thing:426125 06/02/2015: Car Panel Clip (2 Versions, 4 parts!) http://www.thingiverse.com/thing:665635