BMW i4 central console organizer preview

Files (1)

BMW i4 Center Organizer.stl

STL

915.0 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 15%	100% solid	Recommendation
BMW i4 Center Organizer.stl	Primary model	915.0 KB STL	Slice file	Slice file	Slice file	Print the main part with PETG or ASA for better heat resistance in hot climates.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

BMW i4 central console organizer

0 downloads38 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for heat resistance, PLA for decorative/interior-only

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

15% honeycomb for texture, adjust according to desired flexibility

Difficulty

Not rated — inspect geometry

Vehicle heat

Low-heat or decorative use only

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This two-part print is an organizer for the central armrest / console of a BMW i4. It was designed for a 2023 Edrive40 but I expect it will fit all i4 models. The main part is designed to allow easy access to the USB C port and can be printed in any filament you want. If you are in extremely hot climates you might consider printing in PETG or ASA instead of PLA for heat resistance. However, mine is in PLA and this hasn't been a problem. I printed the insert in TPU/flex to make the bottom a bit grippier, but this is optional. The insert was also printed with 0 top layers and an infill of 15% honeycomb to generate the texture you see in the photos.