Files (1)

Bracket.stl

STL

64.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 80%	100% solid	Recommendation
Bracket.stl	Mount / bracket	64.8 KB STL	Slice file	Slice file	Slice file	Increase wall thickness for added strength

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Front Bumper

Bumper Light Bracket

0 downloads48 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

So the new front bumper (Barricade Extreme HD Full Width Front Bumper) I put on my jeep came with new LEDs for the fog lights. At the same time it was designed to reuse the OEM lights from the old bumper. So I did. In order to mount the extra LEDs, I needed a bracket. At first I thought about making it out of an extruded channel, but none of my local sources had anything close to the size I needed. 3D Printer to the rescue. I printed mine out of PETG at twice the normal wall thickness and 80% fill. The test/fit check part took 1hr 30min, but final parts took 4hr 50min each. They feel pretty stout. Time will tell how they hold up. The FreeCAD file is included just in case someone needs to make changes.