Jeep Wranger (JK) Fog Light Mount - image

Files (1)

Jeep_Wrangler_Foglight_Holder.stl

STL

818.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 75%	100% solid	Recommendation
Jeep_Wrangler_Foglight_Holder.stl	Mount / bracket	818.6 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Front Bumper

Jeep Wranger (JK) Fog Light Mount

0 downloads48 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I have an aftermarket bumper on my Jeep and the ends of the winch were hitting the stock fog light mounting bracket/cup. This design moves the fog light forward about 13 mm and completely eliminates the box back of the original bracket. It also eliminates the need for the adjustment screw behind the fog light by extending to the front bezel of the fog light and holding it still. The original design is in OnShape: here - No rafts - No support - 75% infill (for strength) - Printed with PETG for strength/flexibility - 4 top layers, bottom layers, and walls - The cylinder should be a solid - 0.2 print resolution Ignore the zits on the print. New computer/slicer installation and I have not spent the time fine tuning the slicer yet.