Files (1)
Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 100% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| s10throttlekeep.stl | Primary model | 26.1 KB STL | Slice file | Slice file | Slice file | Print at a slower speed for better layer adhesion |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Chevy S-10 throttle cable clip
Shared by
3DPrintedCarPartDescription
This is a throttle/cruise control cable clip for a 2001 Chevy S-10 with the 4.3L Vortec V6. The original clip degraded and broke allowing unwanted movement and rubbing on the cables. This is a 2 piece part that snaps together over the metal ferrule and then clips in to a plate over the engine to keep the cables from moving. Both the throttle and cruise control cables use the same clip....just oriented backwards (there is a tab on the clip that matches the notches on the cable plate). I used PETG as it is a good flexible and heat worthy material. I first tried PLA and the clip "wings" that flex during installation into the plate would break off. The PETG clips do not break and hold the cables in place very well (so far it's only been a few weeks of testing). Print at.2, 100% infill, no supports and print at a slower speed - I use 30mm/s. Hope this can help and let me know how it works for you!
Compatible Cars
Originally published on thingiverse.com by Dean Bogner (Usagoal) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
