Files (2)

Dashcam_Mount_for_Matego_MG380G_-_Ball_Clamp.stl

STL

113.1 KB

Dashcam_Mount_for_Matego_MG380G_-_Windshield_Plate.stl

STL

93.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Dashcam_Mount_for_Matego_MG380G_-_Ball_Clamp.stl	Mount / bracket	113.1 KB STL	Slice file	Slice file	Slice file	Ensure a strong bond between the print bed and the model for optimal adhesion.
Dashcam_Mount_for_Matego_MG380G_-_Windshield_Plate.stl	Mount / bracket	93.7 KB STL	Slice file	Slice file	Slice file	Ensure a strong bond between the print bed and the model for optimal adhesion.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Dashcam Mount for Matego MG380G

0 downloads35 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Designed to fit the Matego MG380G and a Toyota Tacoma windshield, but should fit other applications. Ball is 16mm. Windshield angle is 57 degrees. Holes are designed for M5 bolts and nuts. 25mm long bolt is about right to thread without sticking out too far and reaching the windshield.