Files (3)

Defender_switch_mount_v1.stl

STL

447.0 KB

E_switch_plug.stl

STL

48.9 KB

hazard_switch_plug.stl

STL

60.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Defender_switch_mount_v1.stl	Mount / bracket	447.0 KB STL	Slice file	Slice file	Slice file	Ensure a stable printing surface to avoid warping.
E_switch_plug.stl	Printable file	48.9 KB STL	Slice file	Slice file	Slice file	Ensure a stable printing surface to avoid warping.
hazard_switch_plug.stl	Printable file	60.7 KB STL	Slice file	Slice file	Slice file	Ensure a stable printing surface to avoid warping.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

E-Switch male connectors

0 downloads31 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I don't like to cut into a factory vehicle wiring loom so I created these connectors to plug into the original pre-Td5 Land Rover Defender 90/110/130 lower dash switches. The connectors utilize the 3mm pin connectors commonly found in classic British vehicles. The connectors click into place when inserted into the print. From there you can create your own jumpers to whatever you prefer. I chose Carling switches. I also designed a close to original frame/mount for the new switches.