Land Rover Defender Switch Panel - For Carling Switches preview

Files (1)

Land Rover Defender Switch Panel - For Carling Switches.stl

STL

447.0 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Land Rover Defender Switch Panel - For Carling Switches.stl	Primary model	447.0 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

Land Rover Defender Switch Panel - For Carling Switches

0 downloads12 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for durability and heat resistance

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for strength and moderate weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a replacement pre-Td5 Land Rover Defender lower dash switch panel for use with Carling switches. If you prefer not to cut the original factory connectors - I also created adapters for making your own harnesses that plug into the original E-switch connectors. The adapters utilize the Lucas Rists Round Male Term 20-16awg (3mm pin) connectors commonly found in classic British vehicles. The pin connectors click into place when inserted into the print. Carling switch bodies and rockers pictured can be found at Mudstuff UK.