Files (1)

500e_Charger_Ceiling_Mount_v2.stl

STL

825.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
500e_Charger_Ceiling_Mount_v2.stl	Mount / bracket	825.3 KB STL	Slice file	Slice file	Slice file	Print without supports as designed

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Fiat 500e Charger Ceiling Mount

0 downloads42 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I couldn't find a good place for my charger, so I mounted it on the ceiling. I imagine you could mount it on a wall with this. Flip part, print without supports. Break off the support for the retention tab (see picture, rectangle that runs along cylinder's wall, parallel to axis). Slide the part on to the charger (ideally it clicks as supported nub catches over wire sheath on charger) and screw in place.