Files (4)

FiatPhoneMountBall.STL

STL

260.3 KB

FiatPhoneMountBall17.4mm.STL

STL

283.3 KB

FiatPhoneMountWithBall50deg.STL

STL

616.5 KB

NavInsertLatch2.STL

STL

200.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

4 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ABS 20%	PETG / ABS 25%	100% solid	Recommendation
FiatPhoneMountBall.STL	Mount / bracket	260.3 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in slicer for optimal support generation
FiatPhoneMountBall17.4mm.STL	Mount / bracket	283.3 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in slicer for optimal support generation
FiatPhoneMountWithBall50deg.STL	Mount / bracket	616.5 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in slicer for optimal support generation
NavInsertLatch2.STL	Printable file	200.3 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in slicer for optimal support generation

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Fiat phone holder

0 downloads41 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Phone holder for Fiat Punto Evo, Alfa Giulietta, Fiat 500, Alfa Mito and maybe some others that use Fiat's standard TomTom navigation socket. In some cars (e.g. Giulietta) phone only fits horizontally. Requires 1.5mm rods (10mm long?) for hinges, ballpoint pen spring or piece of thin rubber hose for latch, partially threaded socket head M4x60mm screw with nut for reinforcement. The 17.5mm ball fits most available suction cup holders, if not, use smaller one or remix (that part is simple). Print in ABS or PETG or other temp resistant filament only! PLA will turn into a puddle of plastic in the summer. Sorry, no good photos, the car got sold:(.