GPS dash mount for 2015 Toyota Sienna - image

Files (6)

Ball.stl

STL

277.1 KB

Connector_thin_curved.stl

STL

45.6 KB

Dash_mount_with_screw_hole.stl

STL

83.1 KB

Dash_mount_without_screw_hole.stl

STL

22.6 KB

GPS_mount_complete.stl

STL

695.2 KB

GPS_mount_main_part.stl

STL

267.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

6 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Ball.stl	Printable file	277.1 KB STL	Slice file	Slice file	Slice file	Use a small brim for the main part to prevent warping
Connector_thin_curved.stl	Printable file	45.6 KB STL	Slice file	Slice file	Slice file	Use a small brim for the main part to prevent warping
Dash_mount_with_screw_hole.stl	Mount / bracket	83.1 KB STL	Slice file	Slice file	Slice file	Use a small brim for the main part to prevent warping
Dash_mount_without_screw_hole.stl	Mount / bracket	22.6 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
GPS_mount_complete.stl	Mount / bracket	695.2 KB STL	Slice file	Slice file	Slice file	Use a small brim for the main part to prevent warping
GPS_mount_main_part.stl	Mount / bracket	267.6 KB STL	Slice file	Slice file	Slice file	Use a small brim for the main part to prevent warping

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

GPS dash mount for 2015 Toyota Sienna

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Removable GPS mount for our 2015 Toyota Sienna. This mount keeps the GPS at the correct location without covering any of the windshield. The only part that stays attached is the small part on the dash (dash mount with or without screw hole). The ball was glued in using ABS dissolved in acetone. We route the wires with thing:1510180. I printed the main part with support and a small brim. ABS plastic.