Files (1)

Emblem_Plug_v4_-_Copy.stl

STL

221.5 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Emblem_Plug_v4_-_Copy.stl	Primary model	221.5 KB STL	Slice file	Slice file	Slice file	Ensure a brim or raft is used for stability if necessary

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Emblems/Badges

Honda Emblem Pin

0 downloads31 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

These are pins/plugs that are made to allow the placement of the emblem to be the same as OEM. the holes are sizes to fit over the emblem pins then the emblem is secured with 3M tape to the car. These just allow the emblem to be centered in the oem holes rather than guessing. if your pins are broken, just use heavy duty adhesive to secure them to the emblem in the correct locations then again use 3M tape to attach to the car. See the photos.