Files (2)

contractor.stl

STL

3.1 MB

Handle.stl

STL

427.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 60%	100% solid	Recommendation
contractor.stl	Printable file	3.1 MB STL	Slice file	Slice file	Slice file	Use a 3mm x 0.6 tap to create threads in the contractor
Handle.stl	Printable file	427.2 KB STL	Slice file	Slice file	Slice file	Use a 3mm x 0.6 tap to create threads in the contractor

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

Honda Hood Pull Replacement

0 downloads30 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This assembly can be used to repair a broken hood release handle on most Hondas. Mine was broken when I purchased the car (08 Element) and there was just the end of the cable remaining. This assembly slides over the larger diameter of the remaining cable and then with the (4) 3mm x 25mm you will tighten the contractor onto the cable end. You will need to use a 3mmx0.6 tap to create the threads in the contractor. Do not over tighten as you will risk pulling the threads out of the contractor. I printed this with PLA at 50% infill.