iPhone MagSafe Tacoma Dash Mount - image

Files (2)

Airbag_Clip.stl

STL

1.5 MB

TacoPhone12_V2.stl

STL

2.4 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Airbag_Clip.stl	Clip	1.5 MB STL	Slice file	Slice file	Slice file	Print the Magsafe piece laying down to minimize supports and prevent damage
TacoPhone12_V2.stl	Printable file	2.4 MB STL	Slice file	Slice file	Slice file	Print the Magsafe piece laying down to minimize supports and prevent damage

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

iPhone MagSafe Tacoma Dash Mount

0 downloads31 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a 2 piece mount to put a magsafe charger in place of the airbag switch on a 95-04 Toyota Tacoma. Print the Magsafe piece laying down Print the dash clip piece on its side with supports. If you print it laying down the tabs will most likely break.