Files (1)

Jeep_Hitch_-_Closed.stl

STL

377.0 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Jeep_Hitch_-_Closed.stl	Primary model	377.0 KB STL	Slice file	Slice file	Slice file	Print with two colors for best logo visibility

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Exterior

Jeep Hitch Cover

0 downloads176 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I love the hitch design by fwillburn but was bothered by the fact it did not properly cover the hitch. This remix includes a 5mm wall after the logo closing the hitch mount. The disadvantage of this design is a single color will wash out the logo. Therefore it is preferred to print in two colors. The logo ends exactly 10mm. The wall begins at that point. So you can change filament at 10 mm as shown in my pictures. The design contains the square of the hitch mount embedded into the logo. Therefore, swapping out the color at the end of the logo print causes the square to be printed in the same color. Not a big deal but not perfect (see my pictures). An alternative is to print 5mm then swap. So the back of the log is the same color as the hitch mount. I created a 3D printable hitch pin to attach the Jeep Hitch Cover to the vehicle. Check it out: http://www.thingiverse.com/thing:2222961