Mazda 6 (2nd gen) cupholder divider - image

Files (1)

cup_holder_divider.stl

STL

6.6 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
cup_holder_divider.stl	Mount / bracket	6.6 MB STL	Slice file	Slice file	Slice file	Check for and remove any artifacts or excess material after printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

Mazda 6 (2nd gen) cupholder divider

0 downloads36 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a replacement divider for the cup holder in the center console of a 2nd generation (something like 2009 - 2013) Mazda 6. It is publicly available over at OnShape if you want to modify it in any way. I sliced off the bottom 0.3mm in Slic3r before I generated the gcode in order to clean up the channels on the sides. OnShape left an artifact right at the bottom when I did the subtraction to create those channels. It was my first time using it, so I couldn't figure out how to fix that. If you can't do that, just take a razor knife and cut it out of there once you print it. It's only going to be 1-2 layers.