Mercedes 190E W201 Vent Surround - image

Files (3)

Vent_Surround.stl

STL

39.4 KB

Vent_Surround_-_Front.stl

STL

128.5 KB

Vent_Surround_-_Back.stl

STL

2.3 MB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

3 model files

Recommended kit

50g

Based on 25% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ASA

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Vent_Surround.stl	Printable file	39.4 KB STL	7g $0.17	8g $0.18	17g $0.40	Use the single complete design for simplicity or the two-part design for easier printing and less warping risk.
Vent_Surround_-_Front.stl	Printable file	128.5 KB STL	10g $0.23	11g $0.25	23g $0.56	Use the single complete design for simplicity or the two-part design for easier printing and less warping risk.
Vent_Surround_-_Back.stl	Printable file	2.3 MB STL	29g $0.70	32g $0.76	70g $1.67	Use the single complete design for simplicity or the two-part design for easier printing and less warping risk.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Mercedes 190E W201 Vent Surround

1 downloads208 views0 likes

Shared by

Michael Chen

Verified

Description

Vent surround for the drivers side. Usually cracks as its made from thin plastic. There is a two part design you can glue together for easier printing as welll as a single complete design. Its not the most accurate model as i never managed to finish this project but it fitted fine in my car. If your country has warm summers print in ABS, PLA just warped into mush for me :'( For LHD just mirror the part before prinitng.