Files (4)

MGB_Switch_Blanking_Plate_-_MG_Logo.stl

STL

98.1 KB

MGB_Switch_Blanking_Plate_-_Plain.stl

STL

92.1 KB

MGB_Switch_Blanking_Plate_-_RAM_Backing.stl

STL

4.8 KB

MGB_Switch_Blanking_Plate_-_RAM_Mount.stl

STL

89.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

4 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
MGB_Switch_Blanking_Plate_-_MG_Logo.stl	Printable file	98.1 KB STL	Slice file	Slice file	Slice file	Ensure proper fit in the center console before printing
MGB_Switch_Blanking_Plate_-_Plain.stl	Printable file	92.1 KB STL	Slice file	Slice file	Slice file	Ensure proper fit in the center console before printing
MGB_Switch_Blanking_Plate_-_RAM_Backing.stl	Accessory piece	4.8 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
MGB_Switch_Blanking_Plate_-_RAM_Mount.stl	Mount / bracket	89.8 KB STL	Slice file	Slice file	Slice file	Ensure proper fit in the center console before printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Center Console

MGB Switch Blanking Plates

0 downloads28 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Plates to fit into unused rectangular switch holes in the MGB center console. Designed for and test fitted on a 1973 car. There are three options included: - Blank plate to fill the hole (replacement for factory part) - Blank plate but with a recessed MG logo - RAM mount, including a 1" ball on a face plate and a backing plate for stability. There is a hole that should accommodate a 1/4" screw. Since this part is designed to be used in a car interior, DO NOT print with PLA... it will melt. Suggested filament is PETG or better.