Files (1)

armrest_unlock_v1.4.STL

STL

39.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
armrest_unlock_v1.4.STL	Primary model	39.8 KB STL	Slice file	Slice file	Slice file	Ensure the wedge is printed with the sliding surface facing upwards for optimal installation

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Center Console

MK7 Golf R Armrest Wedge

0 downloads41 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This wedge will allow you to use your armrest without the ratcheting mechanism catching. Easily just remove the trim piece with vents. Remove the M6 screws holding the ratcheting arms. Install this wedge with M5 flat head screws. (You might be able to tap with the existing M6 screw.) Tip: When installing the wedge, check to make sure the sliding surface for the ratcheting mechanism is as flush a possible. Pushing on the back of the wedge (where the R logo is) while installing helps.