Files (1)

NB_Armrest_Delete_Plug.STL

STL

214.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
NB_Armrest_Delete_Plug.STL	Primary model	214.7 KB STL	Slice file	Slice file	Slice file	Print with the bottom of the piece flat on the build surface for best results

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

New Beetle Armrest Delete

0 downloads32 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Finally got around to making an armrest delete/coin holder for my New Beetle. Its not perfect but it conforms and is easy to install. Feel free to remix if if you can to suit your setup. I attempted printing in various positions. The best I found is laying it with the bottom of the piece flat, then adjusting the angle to make it perfectly flat on the build surface. Using this method you need to be careful when you pull the supports off that you don't break the clips off with them! I would highly recommend making this out of PETG or better since there's a chance of direct sunlight sitting in a hot car.