Nissan 300zx to filter cone adaptor for Mass Air Flow Sensor - image

Files (1)

n62_cone_adaptor.stl

STL

131.0 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

50g

Based on 35% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ABS

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ABS 20%	PETG / ABS 35%	100% solid	Recommendation
n62_cone_adaptor.stl	Primary model	131.0 KB STL	40g $0.95	50g $1.20	95g $2.27	Use PETG or ABS for under-hood temperature resistance

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Exterior

Nissan 300zx to filter cone adaptor for Mass Air Flow Sensor

0 downloads181 views0 likes

Shared by

Michael Chen

Verified

Description

I made this just to test myself with design instead of buying another one that somebody made. This is what I came up with and also my first version of this type. I will revise as needed if I find flaws as I use it. I recommend using PETG or ABS for this because regular PLA will break down in form after awhile due to under hood temps. use either PETG or ABS filament only! If you have a glass plate. use the MAFS side down to create the best seal. when you need this and you have to wait 3- days to get it. Tell us more...with just a gasket and the filter cone. I used the measurements to create this on Fusion 360.