Files (2)

Oil_cap_for_Honda_cars.stl

STL

185.6 KB

Oil_cap_for_Honda_cars_v2.stl

STL

185.0 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 10%	100% solid	Recommendation
Oil_cap_for_Honda_cars.stl	Cover / cap	185.6 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.
Oil_cap_for_Honda_cars_v2.stl	Cover / cap	185.0 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

Oil cap for Honda and Acura

0 downloads47 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Oil cap for Honda/Acura cars. It should fit to most models with threaded oil cap with 32mm diameter. I tested it with my 1996 Honda Civic with D-series engine. NOTE: Keep in mind that engine valve cover can get very hot thus I can't recommend it for daily use (neither do I) especially if you print it with PLA or other material with relatively low melting point. I designed it for emergency purpose when I lost my oil cap and used it for short trips before I got new one.