Files (1)

Can_holder_Boxster_S_986.stl

STL

436.4 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

22g

Based on 25% main infill across listed model files

Material cost

$0.52

Filament only at roughly $24/kg PETG / ASA

Print time

37m–1.0h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Can_holder_Boxster_S_986.stl	Mount / bracket	436.4 KB STL	20g $0.48	22g $0.52	48g $1.15	Ensure the print bed is level and clean for a successful print

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

Porsche Boxster 986 Can Holder

0 downloads44 views0 likes

Shared by

Alfred

Verified

Description

A simple holder that fits perfectly in the Porsche Boxster S 986. Tried it in my 2001, so should fit all in the same range. You could lower the bars holdin the can in place, but i'd rather have them higher to prevent them from being shaken to much. It took me about 7 hours to print, as the base is rather big. Will most likely re-design it in the near future - that's why it's marked as a Work in Progress.