Renault Zoe Rear seat clip 883041628R - image

Files (1)

Zoe_Rear_seat_clip.stl

STL

104.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Zoe_Rear_seat_clip.stl	Clip	104.9 KB STL	Slice file	Slice file	Slice file	Ensure a brim or raft is used if necessary for bed adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Renault Zoe Rear seat clip 883041628R

0 downloads400 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I found that if I removed the rear seat completely and wound the frond seat right back I can get a ladder in the Zoe, which is handy. However after removing the seat base I found the clips holding it down broke (Stupid Renault!) then was rather miffed to find the replacement cost from Renault were so much. This is a remake as the original version by ermdem03 as it didn't have the required catch inside to hold the seat down. I have also made it a bit simpler and it is now manifold so should print without issue. Printed at 0.2mm with 2 shells and 20% infill. It should now fit easily and be reusable at least few times, so in my mind is better than the original Renault item and has saved £21:-O.