Replacement cup holder for a 2009 Tacoma - image

Files (2)

New_cup_holder_V1.stl

STL

258.7 KB

New_cup_holder_V1.stp

STP

307.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
New_cup_holder_V1.stl	Mount / bracket	258.7 KB STL	Slice file	Slice file	Slice file	Ensure the print bed is level and clean for optimal adhesion
New_cup_holder_V1.stp	Mount / bracket	307.1 KB STP	Slice file	Slice file	Slice file	Ensure the print bed is level and clean for optimal adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

Replacement cup holder for a 2009 Tacoma

0 downloads40 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a replacement cupholder for a 2009 Toyota Tacoma. I modeled it in inventor and used the old cupholder as a base model. It does not work with Tervis Tumblers but I will be creating a V2 to fix that problem. It uses about 300 g of filament and needs a 210mm x 105mm x 80mm bed it does not like scaling of obvious reasons. It is 76.2 mm high and 203.2 mm wide 101.6 mm deep.